Login to see pricing...

PRO50-7040 Honda/Tesla 3 Wire .030 (0.8mm)

Be the first to review this product

Availability: In stock

$349.00
OR

Quick Overview

The new wire, Bohler Union X96 0.8mm is approved for high strength and ultra high strength steel welding procedures on 590-980 MPa steel parts, including:
*MAG butt welding on up to 780 MPa steel parts
*MAG plug welding on up to 980 MPa steel parts

Honda approved for AHSS and UHSS HWW-98008
Tesla Approved; (see chart below)

Keep in mind that the Honda wire only gets used on Ultra high strength parts 590-980 MPa
and there is 4240 feet of wire on a spool so while it is expensive it’s only .09 cents per foot
and even if you used 100 feet on a car that’s only 9.00 per job.

**It can also be used on the Tesla model 3

PRO50-7040 Honda/Tesla 3 Wire .030 (0.8mm)

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

Details

When doing Honda-approved MAG welding procedures on 590-980 MPa (86-142 ksi) steel parts, the welding wire must have a tensile strength equal to, or greater than, the lowest tensile strength of the parts being welded. Typical ER70S-6 wire has a minimum tensile strength of 70 ksi (483 MPa) and can only be used when welding up to 440 MPa steel parts. Failure to observe this requirement may cause a weaker-than-intended weld joint, resulting in improper repair.

Additional Information

Weight 11.0000
[profiler]
Memory usage: real: 30932992, emalloc: 30589584
Code ProfilerTimeCntEmallocRealMem